Question 1

How much does a concrete driveway cost in Texas?

Accepted Answer

Published planning references for concrete driveway installation in Texas generally range from $4 to $8 per square foot for basic broom-finished replacement flatwork and $9 to $16 per square foot for more complex custom installations. Decorative stamped concrete typically ranges from $10 to $18 per square foot. Total project cost depends on demolition, excavation, subgrade base preparation, steel rebar grids, drainage requirements, and site access. Every property in Converse and San Antonio receives a detailed, on-site written quote.

Question 2

How soon can I walk or drive on a newly poured concrete slab in Texas?

Accepted Answer

You can walk on new concrete after 24 to 48 hours, but passenger vehicles must wait a minimum of 7 full days. Heavy trucks, RVs, commercial delivery vehicles, and heavy equipment require a full 28-day hydration period per American Concrete Institute (ACI 308) standards to achieve full design compressive strength (3,500 to 4,000 PSI) before parking.

Question 3

Does Texas require a statewide license for concrete contractors?

Accepted Answer

No. Texas does not issue a general statewide business license for concrete contractors. Instead, regulation occurs at the municipal level through city contractor registrations, building permits, right-of-way licensing, and Texas Department of Licensing and Regulation (TDLR) guidelines for residential foundations. Always verify that your contractor carries active general liability insurance, local municipal registrations, and verifiable local project proof.

Question 4

Do you pull municipal permits for driveway replacements and curb cuts?

Accepted Answer

Yes. We coordinate and pull all necessary municipal permits for driveway replacements, curb cuts, and right-of-way approaches with the City of Converse, City of San Antonio Development Services, City of Schertz, or Bexar County Public Works. We verify property setbacks, coordinate utility locates through Texas 811 before digging, and schedule required municipal formwork and final inspections.

Question 5

Why do concrete slabs crack or shift on Texas expansive clay soil?

Accepted Answer

Concrete slabs crack and shift on Texas clay soil because high-PI (plasticity index) clays expand aggressively when wet and shrink severely during drought. Uneven soil moisture creates voids underneath unreinforced flatwork or pushes slabs upward during torrential storms. We prevent structural failure by excavating unstable topsoil, installing mechanically compacted crushed stone bases, tying #3 and #4 rebar grids elevated on chairs, and cutting expansion control joints at 10-foot intervals.

Question 6

Should cracked concrete be repaired or completely replaced?

Accepted Answer

It depends on whether the underlying subgrade is stable. Stable hairline surface cracks under one-quarter inch can often be sealed, patched, or resurfaced with an engineered polymer overlay. However, if the slab has heaved, settled unevenly, suffered broken rebar, or exhibits active subgrade erosion from poor drainage, full tear-out and replacement with a re-engineered subbase is the only permanent solution.

Professional Concrete Services in Converse & San Antonio

All 15 Concrete Solutions

Concrete Contractor

Stamped Concrete

Stained Concrete

Concrete Resurfacing & Overlays

Concrete Driveways

Concrete & Flagstone Patios

Decorative Concrete & Coatings

Concrete Repair

Concrete Leveling & Void Fill

Concrete Demolition & Removal

Concrete Drainage Solutions

Sidewalk & ADA Trip-Hazard Repair

Pool Decks

Commercial Concrete

Patio Extensions

How We Build Slabs That Withstand Texas Soils

Crushed Limestone Base Compaction

Elevated Steel Rebar Reinforcement

3,500–4,000 PSI Ready-Mix Concrete

Precision Control Joint Spacing

Unsure Which Concrete Solution Fits Your Property?

Frequently Asked Questions About Our Concrete Services